These extruder discs are for the large extruder gun which you can find here. Depending on the discs you choose you can create cherries with the stalk and cherry the same colour or cherries with different coloured stalks.
The individual cherry (without stalk) and the stalks have been created to fit together, the cherry is symetrical so it won't matter which way round you attach it to a stalk. If you are making the double cherry you will just need to extrude 2 single cherries and attach to each part of the stalk.
 
Embeds produced for  each of the discs will be the following sizes, please select the discs you require from the drop-down box, a picture will display the embed design as you click on the options:
Single cherry approximately 3.1cm high x 2.3cm wide
Double cherry  approximately 3.4cm high x 3.8cm wide
Overlapping cherries  approximately 3.4cm high x 3.1cm wide
 
These discs are also available in the 18mm, 23mm and 24mm ranges which will give a smaller embed size if required.
 
These discs will fit other large extruders, please just check the size if you have a different extruder. The diameter of the disc is 57mm.
 
The discs are only suitable for use with soap dough, not suitable for melt and pour soap.
 
There is a special postage rate available when buying scrapers and/or extruder discs only, as they can be sent 'large letter' size. Please select this option at the checkout. This postage option cannot be used if your order contains anything other than scrapers and extruder discs.
 
The discs are made from PLA, which is a plant-based material, and therefore environmentally friendly
 
These extruder discs will last you for many uses and help you create many beautiful soaps as long as you take care of them.

After use, wipe with a cloth to remove excess soap batter. I always find the discs easier to clean if you wipe and wash them soon after using.
Wash with warm soapy water, rinse and dry.
Your scrapers are made from PLA which is a temperature-sensitive thermoplastic polymer derived from renewable resources such as corn starch or sugar cane. PLA will start to deform and melt at around 60°C (140°F), please ensure your washing water is below this temperature
and never put your extruder discs in the dishwasher